The MB2B is a tall, compact meter bag built on an impact- and water-resistant injection molded polypropylene base that keeps the bag upright while protecting your tools and test equipment in any environment. The main compartment accommodates two meters up to 12.5” tall, while the large front access sleeve pocket provides convenient storage for hand tools. The bag also features a rear water-resistant pocket ideal for storing leads or probes, and an integrated hang-up hook that keeps the bag elevated, off the ground, and within easy reach.
| PRODUCT SPECIFICATIONS | Height: 330mm Width: 243mm Depth: 140mm Weight (empty): 0.9kg |
|---|---|
| MAXIMIZED TOOL STORAGE CAPACITY | 11 interior and exterior tool pockets of various sizes Large main pocket with 1 padded interior pockets ideal for protecting 1 – 2 meters up to 12.5” tall Tarpaulin covered rear pocket for added weather & abrasion protection “Hang-up” hook – accessible while open and closed Waterproof Polypropylene plastic base 2 D-rings 8" electrical tape strap Detachable over-sized elastomeric carrying handle YKK® zippered pockets |
| OTHER FEATURES | Warranty: 5 Years (see Veto warranty terms and conditions) |
Only logged in customers who have purchased this product may leave a review.
Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
PROTECT THE ZIPPERS FROM SHARP OBJECTS AND/OR EXCESSIVE HEAT
Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
DON'T OVERSTUFF THE BAG
Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed…proceed with caution!
Related products
Hi-Viz Tool Bags
Tool Pouches
Blackout Range
Tool Pouches
Reviews
There are no reviews yet.