TP5B
$150.00
The TP5B is a clip on service tool pouch designed to hold smaller meters and hand tools. With more capacity than the TP4B, it features a plastic hard bottom offering moisture protection and stability, along with a variety of vertical tool storage options.
| PRODUCT SPECIFICATIONS | Width: 203mm Length: 89mm Height: 280mm Weight: 1.1kg (empty) |
|---|---|
| MAXIMIZED TOOL STORAGE CAPACITY | Vertical Tool Pockets: 20 interior and exterior Small Meter Pockets Flap Bit Pocket 64mm Wide Belt Slot Adjustable Velcro Tool Loops D-Rings: 2 small 203mm Electrical Tape Strap |
| RUGGED MATERIALS & CONSTRUCTION | Leather Trim Panels D-Rings: Powder Coated Steel |
| OTHER FEATURES | Detachable Rubber Handle Metal Tape Clip Holder Metal Pouch Clip Warranty: 5 Years (see Veto warranty terms and conditions) |
KEEP THE ZIPPERS CLEAN AND LUBRICATED
Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
PROTECT THE ZIPPERS FROM SHARP OBJECTS AND/OR EXCESSIVE HEAT
Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
DON'T OVERSTUFF THE BAG
Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed…proceed with caution!
Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
PROTECT THE ZIPPERS FROM SHARP OBJECTS AND/OR EXCESSIVE HEAT
Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
DON'T OVERSTUFF THE BAG
Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed…proceed with caution!
Related products
Tool Pouches
$230.00
Tool Pouches
$117.00
Tool Pouches
$219.00
Tool Pouches
$96.00